Aluminum undertray (engine splash shield)
#21
Wow, for the cost/effort of me doing this, this one actually seems affordable to me.
And it looks good and functional. Kindof am a fan of the "slot/tab" actually since my plastic one is so outta wack its a pain to put it back up all in one piece.
Thanks for the find, Added to Hanukkah list.
And it looks good and functional. Kindof am a fan of the "slot/tab" actually since my plastic one is so outta wack its a pain to put it back up all in one piece.
Thanks for the find, Added to Hanukkah list.
#22
Mine just got in two days ago. It'll be a bit before I install as I have to drill out and retap some seized bolts/studs where these would mount.
Also have to measure out and cut areas for my charge piping. I can already see that some additional fab will be required since my intercooler hangs lower than where the tray mounts
Also have to measure out and cut areas for my charge piping. I can already see that some additional fab will be required since my intercooler hangs lower than where the tray mounts
#29
The fact that's it's rigid helps especially when your trimming for intercooler piping. I nearly cut all the mounting points from my oem under tray and it doesn't extent to the front of the bumper like the aluminum does. To make a long story long, if the stock undertray is no longer a solution for you, this can be. Otherwise, toss a coin.
Thread
Thread Starter
Forum
Replies
Last Post
albuquerquefx
Build Threads
142
02-05-2020 01:30 PM
Sean
Miata parts for sale/trade
11
10-23-2015 02:47 PM
elijahmckay
Meet and Greet
5
10-20-2015 12:55 PM