since I maybe out shopping for new injectors I found a set of these locally extremely cheap. The are 460cc hi but use a square connector. I've read that the pigtails can be purchased.

Has anyone actually used this in a Miata?

 

looks good to me

 

195500-1350 come in both a high and low-ohm, make sure you get high, because not only will you need to wire in pigtail, but resistors as well.

i believe it would fit these: http://flyinmiata.com/index.php?dept...umber=04-46900
or these: http://flyinmiata.com/index.php?dept...umber=04-46910

someone should double check me on that.

 

The injectors are supposed to be out of an 88 NA RX7, which would make them high. Obviously I would test them before installing too.

 

There were mid year changes from hi to low with the turbo II. I'd check to be sure. I'm running the 1390s - square connector, 550cc. Got the pigtails from Napa for $2-3 each and just shaved the offset ridge off the injector.

 

These aren't the TII injectors, but from the 88 NA. Physically they should fit I'd think?

Jay

 

right- the 1390s are the same but 100cc "larger". Physical fit yes, but I'd put a meter on them to be sure.