Personally I like the 3M three part system. I used it on my '99 subaru and noticed more power and there was even a change in the way the exhaust sounds.

 

ok heres the car running.. i did a little bit more seafoam in thru that other line and took this video after but that made a HUGE diffrence in noise

MOV00254.flv video by bayside-blue - Photobucket

 

lol that is NOT lifter tick

 

good to know.. it will have a new engine in a couple days and back up and running

 

sounds like rod knock. looks like a failed short nose.

 

That crank is jank.

 

Looks like your crank is wobbling BAD.

 

That sounds a lot like my motor did when i bent the rod, lol.

Good luck...

 

That's what I thought at first but the motor is a 92 and the short nose is 90 and early 91's

 

Now's a good time to rev it to 10,000 rpm.

 

i say blow it up

 

think i can drive it 40 miles??
it runs and drives.. i tried it in my driveway lol

if i can make it to the shop ill put my motor that was going to go in my 91 in here

 

probably, will be a fun drive.

 

I've seen plenty of bad crank noses on long nose cranks. It's a matter of not having reassembled the crank pulley properly. Had a club member have the crank problem 5,000 miles after having had the dealer do a timing belt!!

 

the motor did have ~190k on it so maybe the same thing happend.. oh well ..ill push it till its done, then call AAA.. thats what i pay them for anyway lol

 

Since it happened during seafoaming and not a timing belt change. My money is still on a bent rod. WHEN my diagnosis is proven correct, you can all bow down to me.

 

either way the motor was going to be junked soon..

lesson learned no real harm.. it was sad at first but now its kinda funny. its the first motor ive ever blown up.. thank fully its not my built motor cuz then id be pissed alot

i have no idea the history of hte car but the 200 or so miles ive put on it since i got it i beat the heck out of it.

 

Good possibility but I was just addressing the fact that a long nose crank can be crap too if the person doing the work screws up.

 

well i just tried driving the car to the shop.... made it 1.5 miles

not a single abnormal sound once i made it out on the street tho..

it was running fine then it shut off and wouldnt start again..the whole time my battery light was on as well

 

cause your crank wobble was barely allowing the alternator to spin, im sure your water pump wasn't spinning either.

that junk is toast, in for bent rod and melted pistons pictures.