Will LC-1 keep memory after disconnected?
#1
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,025
Total Cats: 304
Will LC-1 keep memory after disconnected?
I may have asked this before, but I can't find any old threads. The question is simple. If I take my LC-1 controller, disconnect the sensor, then move everything to another vehicle...Will it keep the calibration and all the settings I put on there before? Or will I have to redo calibration and everything all over again?
#2
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Yes it will retain it's settings.
When you connect it up there's no requirement for a permanent 12v feed, merely one supplied once the ignition is turned on.
So when the ignition is off, it's effectively unplugged and in a box somewhere in your cupboard.
That said there's no harm whatsoever in performing a new calibration.
When you connect it up there's no requirement for a permanent 12v feed, merely one supplied once the ignition is turned on.
So when the ignition is off, it's effectively unplugged and in a box somewhere in your cupboard.
That said there's no harm whatsoever in performing a new calibration.
#5
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
well it will automatically recalibrate if it's ever powered up without a sensor and then one is connected. and it will screw up if it's not done correctly in free air and then the warmup calibration will also be screwed.
Thread
Thread Starter
Forum
Replies
Last Post
SuperSneakySecretSquirrel
Meet and Greet
5
09-06-2015 08:30 PM