Very scary compression numbers on my turbo car
#63
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Yes, this is correct. You cannot dispute the howling air on the leak test through the exhaust. I was hoping to get a baseline number where the numbers were close on more than one cylinder, it's clear the engine is blown.
I'm also thinking I had detonation or something although I never heard it on the dyno. That's basically the only excuse for eroded, leaky valves.
I'm also thinking I had detonation or something although I never heard it on the dyno. That's basically the only excuse for eroded, leaky valves.
I'm with mgeoffriau, you need a proper compression tester before you do anything like pull the head.
It's bonkers to be worrying about something when there's no evidence other than a tester which gives funny readings on more than one car.
#64
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
I don't understand, aren't exhausts supposed to leak? If they didn't engines wouldn't run...
I'm with mgeoffriau, you need a proper compression tester before you do anything like pull the head.
It's bonkers to be worrying about something when there's no evidence other than a tester which gives funny readings on more than one car.
I'm with mgeoffriau, you need a proper compression tester before you do anything like pull the head.
It's bonkers to be worrying about something when there's no evidence other than a tester which gives funny readings on more than one car.
#67
I don't understand, aren't exhausts supposed to leak? If they didn't engines wouldn't run...
I'm with mgeoffriau, you need a proper compression tester before you do anything like pull the head.
It's bonkers to be worrying about something when there's no evidence other than a tester which gives funny readings on more than one car.
I'm with mgeoffriau, you need a proper compression tester before you do anything like pull the head.
It's bonkers to be worrying about something when there's no evidence other than a tester which gives funny readings on more than one car.
if he had serious detonation, there would be broken rings/ringlands, before any valve problems. there would also be a hammertone finish on the pistons, which could be verified by putting #1 at tdc and shining a light in there.
#69
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
Comp TDC on every cylinder. I'm going home to check lash again. The exhaust side is a little tight for my taste.
#70
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
It's been a while since I **** blood as a physiological symptom of stress. Maybe I'll get back there this weekend at the track when I think about the bill to tow my car home from the track incessantly while not enjoying the weekend.
#79
You may just have some worn valve springs that aren't pulling the valves shut firmly enough.
EDIT: I recall a story similar to this from my auto mechanics class in high school. The car would drive normal, but the compression test or whatever would show a leak. It turned out that one of the valve springs actually cracked/broke so that it had enough spring to pull the valve shut, but not hold it shut very tightly.
#80
FWIW, when I've done leakdown tests, I often see the valves leaking slightly. I think it's due to bits of carbon or something getting stuck between the valve and the seat and preventing a complete seal. If you crack the exhaust valve open with pressure in the cylinder, that'll usually blow it loose, then go back and it will seal.
--Ian
--Ian