UTCC / Hyperfest 2018
05-18-2018, 01:00 PM
#100
Ryan is ok. Splitter is tore up and pretty much unusable.
So utcc is split up into a and b groups. A group before us had no less than 3 full course yellows and they kept restarting the group. They were on track for 45 minutes. B group just afterwards got one full course yellow and they stopped the session.
The track was fully wet about a half hour before we went out so we mounted the H2O s. They delayed getting our group on track 20 minutes for a spun car. By the time out I got out it was a full dry line. So I dove back into the pit to swap to A7 scrubs. Started pouring on the out lap. Aargh!
So my best time lap was on slicks in the wet. Scared the **** out of myself but I made the cut. If the track gets faster we will go a lot faster. If it does not get any faster than we're good for tomorrow.
Ryan is pretty sulken right now as you might imagine. We are trying to talk him into rigging up some other splitter. We have enough pieces and Hardware here to put something together that will work. We will have to trim the rear wing way out and he will lose some downforce but the top end speed will probably go up.
So utcc is split up into a and b groups. A group before us had no less than 3 full course yellows and they kept restarting the group. They were on track for 45 minutes. B group just afterwards got one full course yellow and they stopped the session.
The track was fully wet about a half hour before we went out so we mounted the H2O s. They delayed getting our group on track 20 minutes for a spun car. By the time out I got out it was a full dry line. So I dove back into the pit to swap to A7 scrubs. Started pouring on the out lap. Aargh!
So my best time lap was on slicks in the wet. Scared the **** out of myself but I made the cut. If the track gets faster we will go a lot faster. If it does not get any faster than we're good for tomorrow.
Ryan is pretty sulken right now as you might imagine. We are trying to talk him into rigging up some other splitter. We have enough pieces and Hardware here to put something together that will work. We will have to trim the rear wing way out and he will lose some downforce but the top end speed will probably go up.
__________________
Reply
0
0
