Rasta420

hello. I have an 02 with MS3Pro Plug and Play MM0105 for the 01-05 Mazda Miata – Manual Trans. I am using an innovate LC2 and have the brown wire from LC2 controller soldered into Analog IN 2, set it to that in TS but the gauge never changes from 7.5 to 22.4 when the controller does. I have the yellow wire from the LC2 controller going to the gauge and it appears to be working correctly.
I "think" this is wired correctly but for some reason doesn't read accurately in TS.

Any helpis greatly appreciated.

Thanks

Matt Cramer

Please connect to the LC2 and make sure the analog output 2 is set for a 0-5 volt output and not simulated narrow band mode.

Rasta420

Thanks Matt. I am at work right now and will try this evening and report back.

Rasta

Rasta420