20+psi at zero RPM!
#1
Senior Member
Thread Starter
iTrader: (14)
Join Date: Oct 2006
Location: South East Florida
Posts: 677
Total Cats: 6
20+psi at zero RPM!
That's how I start my car bitches!
Turn the key to prime the fuel pump: MS turns on, fires the coils, and in turn the plugs spark, and I get a large 'poooooooffffff' sound with the accompanying pegging of the boost gauge.
The car is difficult to start after this happens, and takes around five seconds of cranking followed by a stumble that takes close to a half minute to clear.
This does not happen on every start. Most frequently it seems to happen when I start my car to leave work, after maybe 10 hours or so. Does not seem to do it as often, if at all, in the morning after sitting all night, and starts crisply.
This would be a MS1 running TunerStudio on a 1994.
How do you suggest that I eliminate this problem? I can not imagine that it is healthy for the engine...
Videos tomorrow as long as I get both conditions.
Turn the key to prime the fuel pump: MS turns on, fires the coils, and in turn the plugs spark, and I get a large 'poooooooffffff' sound with the accompanying pegging of the boost gauge.
The car is difficult to start after this happens, and takes around five seconds of cranking followed by a stumble that takes close to a half minute to clear.
This does not happen on every start. Most frequently it seems to happen when I start my car to leave work, after maybe 10 hours or so. Does not seem to do it as often, if at all, in the morning after sitting all night, and starts crisply.
This would be a MS1 running TunerStudio on a 1994.
How do you suggest that I eliminate this problem? I can not imagine that it is healthy for the engine...
Videos tomorrow as long as I get both conditions.
#2
Look up JoeP's 'better ignition circuit'.
Basically what is happening is residual fuel (most likely from leaking injectors) is pooling in your cylinders. When the key hits the 'ON' position, the coils fire and you get a backfire through the intake manifold. Since your throttle plate is most likely closed, the huge pressure spike you are seeing is actually the result of combustion pressure.
Joe's mod changes the way the ECU drives the ignitor. An added benefit to joe's design is that you don't need to unplug your ignitor when you flash new firmware .
Basically what is happening is residual fuel (most likely from leaking injectors) is pooling in your cylinders. When the key hits the 'ON' position, the coils fire and you get a backfire through the intake manifold. Since your throttle plate is most likely closed, the huge pressure spike you are seeing is actually the result of combustion pressure.
Joe's mod changes the way the ECU drives the ignitor. An added benefit to joe's design is that you don't need to unplug your ignitor when you flash new firmware .
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM