3D Printed NB2 Mounts for MSLabs MS3 Basic (and more?)
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Dec 2007
Location: Nooga, TN
Posts: 113
Total Cats: 0
3D Printed NB2 Mounts for MSLabs MS3 Basic (and more?)
I wanted a way to securely mount my MS3-basic in the factory location, but I couldn't find an existing design.
Are these useful to anyone else? No idea if Reverant uses the same cases for all his ECUs or even if the NBs all use the same mounting points. These still need a bit of tweaking (front firewall mount sticks out 5-10mm too far as is), but they hold it right where it should be. I used velcro to hold the lock relay to the ECU as it will NOT fit with this installed.
Are these useful to anyone else? No idea if Reverant uses the same cases for all his ECUs or even if the NBs all use the same mounting points. These still need a bit of tweaking (front firewall mount sticks out 5-10mm too far as is), but they hold it right where it should be. I used velcro to hold the lock relay to the ECU as it will NOT fit with this installed.
Thread
Thread Starter
Forum
Replies
Last Post
Neko
MEGAsquirt
19
05-14-2021 10:35 PM