About ready to set fire to this car........
#21
When uploading firmware the batter voltage in the car is given at 12.4v if I remember correctly.
The car starts pretty well from cold its just that it wont come off warmup enrichment because the CLT reading is stuck at -40 degrees C. To get the car to idle properly, I put 100% in the -40 deg C box in WUE and it then idles with a close to stoich AFR.
This in turn gives the problem that it wont start when warmed up, again as there is no CLT reading.
The car starts pretty well from cold its just that it wont come off warmup enrichment because the CLT reading is stuck at -40 degrees C. To get the car to idle properly, I put 100% in the -40 deg C box in WUE and it then idles with a close to stoich AFR.
This in turn gives the problem that it wont start when warmed up, again as there is no CLT reading.
#28
The never ending saga continues........
Its running like a dog.
Ive:
fitted the GM Ait sensor, its just sat next to my air filter to replace the AFM for now
Fixed my CLT wiring and its working now
Jumpered FP and GND for fuel pump
Flashed the firmware using the download-firmware.bat file in the non-afm folder
Uploaded the PNP non-afm map
Adjusted req-fuel for injectors (340cc)
Adjusted the cranking PWs a little.
AFRs are 21 ish, which is obviously wrong as it wouldnt run, must be missing a cylinder? Seem to be getting spark to all 4 plugs though although they do look a little black, only 2 weeks old plugs.
Heres the .msq and log of me starting it up. I only blip it once or twice in this log, most of the fluctuations the car is doing by itself
megasquirt200908151311.msq
*****.xls
Its running like a dog.
Ive:
fitted the GM Ait sensor, its just sat next to my air filter to replace the AFM for now
Fixed my CLT wiring and its working now
Jumpered FP and GND for fuel pump
Flashed the firmware using the download-firmware.bat file in the non-afm folder
Uploaded the PNP non-afm map
Adjusted req-fuel for injectors (340cc)
Adjusted the cranking PWs a little.
AFRs are 21 ish, which is obviously wrong as it wouldnt run, must be missing a cylinder? Seem to be getting spark to all 4 plugs though although they do look a little black, only 2 weeks old plugs.
Heres the .msq and log of me starting it up. I only blip it once or twice in this log, most of the fluctuations the car is doing by itself
megasquirt200908151311.msq
*****.xls
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM