Another no-tach issue
Thread Starter
Newb
Joined: Nov 2017
Posts: 17
Total Cats: 0
Another no-tach - fixed.
car is a 95.5, 3 wire coil - MSlabs ms2 basic
problem solved,
depinned b/w wire from 1f, and repinned into blank spot into 2I, tach works fine now.
problem solved,
depinned b/w wire from 1f, and repinned into blank spot into 2I, tach works fine now.
Last edited by trance|ghost; Mar 7, 2018 at 07:46 PM.
Reply
0
0
Junior Member
Joined: Feb 2018
Posts: 74
Total Cats: 1
From trubokitty.com:
"Using a spare 1K resistor from your assembly kit and jump IG- and B+ in your diagnostics box (located near the driver shock tower). Shape the resistor into a wide “U” and trim the legs down so it fits inside the cover. Make sure it doesn’t touch any other pins -- B+ connects directly to the battery."
This should restore signal to your tach gauge.
"Using a spare 1K resistor from your assembly kit and jump IG- and B+ in your diagnostics box (located near the driver shock tower). Shape the resistor into a wide “U” and trim the legs down so it fits inside the cover. Make sure it doesn’t touch any other pins -- B+ connects directly to the battery."
This should restore signal to your tach gauge.
Last edited by mj1176; Mar 6, 2018 at 10:52 AM. Reason: clarification
Reply
0
0
Thread Starter
Newb
Joined: Nov 2017
Posts: 17
Total Cats: 0
I thought that fix only worked for the 94-95.5 cars
my car is a later build 95
ive been trying to confirm with rev this issue, I know the ms2e has a tach output, but not sure if it was catered specifically to the late 95 model car I have
my car is a later build 95
ive been trying to confirm with rev this issue, I know the ms2e has a tach output, but not sure if it was catered specifically to the late 95 model car I have
Reply
0
0
Thread Starter
Newb
Joined: Nov 2017
Posts: 17
Total Cats: 0
Reply
0
0
Thread Starter
Newb
Joined: Nov 2017
Posts: 17
Total Cats: 0
Solved
I wish someone made this a sticky for others to easily find
just had to depin the factory harness at 1f, for the 3 wire coil cars, and repin to 2i
problem solved
I wish someone made this a sticky for others to easily find
just had to depin the factory harness at 1f, for the 3 wire coil cars, and repin to 2i
problem solved
Last edited by trance|ghost; Mar 6, 2018 at 10:10 PM.
Reply
0
0
Thread Starter
Newb
Joined: Nov 2017
Posts: 17
Total Cats: 0
I already solved the issue
it was super simple... only applies for 95.5 - 96 obd1.5 cars, the wierd ones... just gotta move a pin on the factory harness, 5 min fix
took two days to realize it however
it was super simple... only applies for 95.5 - 96 obd1.5 cars, the wierd ones... just gotta move a pin on the factory harness, 5 min fix
took two days to realize it however
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
