new mspnp install running rough
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Pittsburgh, pa
Posts: 78
Total Cats: 0
new mspnp install running rough
Hello,
I have a 1990 miata with a 1.6l turbo charged intercooled, with an lc1 wideband. It also has the iat sensor installed. It has 305cc injectors. I have set base timing and adjusted cranking pw's with the pw calculator. I have done 3 datalogging sessions and the car improved on the first one but i actually think has gotten worse since then. I have been reading alot of post but cant find the problem. I have attatched my megatune file if anyone can give me some advice. Thanks
I have a 1990 miata with a 1.6l turbo charged intercooled, with an lc1 wideband. It also has the iat sensor installed. It has 305cc injectors. I have set base timing and adjusted cranking pw's with the pw calculator. I have done 3 datalogging sessions and the car improved on the first one but i actually think has gotten worse since then. I have been reading alot of post but cant find the problem. I have attatched my megatune file if anyone can give me some advice. Thanks
#2
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Pittsburgh, pa
Posts: 78
Total Cats: 0
also i am currently only running 5psi till i get tuning sorted out. also i am a little confused onsetting up lambda afr and open loop mode. i have done research and think i have a good starting point for the afr targets for table 1 but not sure about settings on open loop, should it be zero or 52 as it came? thanks
Last edited by 1990mbt; 09-15-2009 at 09:52 PM.
Thread
Thread Starter
Forum
Replies
Last Post