Correct Pinout for OIL PSI on PNP setup?
Correct Pinout for OIL PSI on PNP setup?
I am putting a MS3propnp on my 97 miata, I am switching the car over to a vvt setup so adding/changing some things and would like to use the oil pressure safety features that ms3pro has but not sure what the correct pin out is for the sensor? OEM the pressure sensor just goes to the cluster so not sure the correct spot on ECU I should be running it to.
Ms3pro has the pins numbered, and they are printed on the board, but the plug and play uses a different system to label the pins. I am adding a oil pressure sensors and a JEEP IAC so a complete pinout would be helpful. I don't see any mention of OIL psi in the manual for the pnp setup so sorry if this is obvious.
This is the unit I got.
https://www.diyautotune.com/product/ms3 ... ual-trans/
Ms3pro has the pins numbered, and they are printed on the board, but the plug and play uses a different system to label the pins. I am adding a oil pressure sensors and a JEEP IAC so a complete pinout would be helpful. I don't see any mention of OIL psi in the manual for the pnp setup so sorry if this is obvious.
This is the unit I got.
https://www.diyautotune.com/product/ms3 ... ual-trans/
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
SilentSeb
DIY Turbo Discussion
8
May 3, 2021 10:49 AM
Oldturbguy
DIY Turbo Discussion
25
Apr 5, 2020 02:41 PM
rustrocket
Miata parts for sale/trade
1
Jun 18, 2019 01:18 PM
