Cylinder 1 - no fuel
#62
Senior Member
Thread Starter
iTrader: (2)
Join Date: Sep 2009
Location: Edmonton, AB, Canada
Posts: 1,193
Total Cats: 29
Thank you.
Now that you say that it makes sense, I should have figured that relationship out.
Much more crowded in that area to remove and install, going to be fun.
Are the injector chips on the board all a bad batch, should I just swap the others as well, or is this a rare double failure on the same build?
Now that you say that it makes sense, I should have figured that relationship out.
Much more crowded in that area to remove and install, going to be fun.
Are the injector chips on the board all a bad batch, should I just swap the others as well, or is this a rare double failure on the same build?
#67
Senior Member
Thread Starter
iTrader: (2)
Join Date: Sep 2009
Location: Edmonton, AB, Canada
Posts: 1,193
Total Cats: 29
I threw it together with just the #4 replaced. Runs like it should.
I'll replace the entire proto board one of these days. It's tight in there when compared to the chip out on the main board.
Thanks again for all the help !!
I'll replace the entire proto board one of these days. It's tight in there when compared to the chip out on the main board.
Thanks again for all the help !!
Thread
Thread Starter
Forum
Replies
Last Post
_spyder
Engine Performance
3
05-28-2011 12:34 PM