DIY Base MSQ into HR?

Reply Subscribe

Thread Tools

Search this Thread

Oct 6, 2008 | 04:26 PM

kenzo42

Thread Starter

Elite Member

iTrader: (6)

Joined: Sep 2007

Posts: 2,017

Total Cats: 13

From: CA

DIY Base MSQ into HR?

Can I run the DIYautotune base map on the HR firmware?

Will I need to make any initial changes or are they completely compatible? I get 7 errors when loading it on 10G.

Oct 6, 2008 | 04:34 PM

Braineack

Boost Czar

iTrader: (62)

Joined: May 2005

Posts: 80,552

Total Cats: 4,368

From: Chantilly, VA

this one would be good to start for your setup in your sig....buyer beware.

Attached Files

Basemap_HR10g_16L_460cc.msq (35.0 KB, 150 views)

Oct 6, 2008 | 04:49 PM

jobambo

Junior Member

Joined: May 2007

Posts: 380

Total Cats: 0

From: San Diego

braineack, any chance you have one for a stock 94 ac ps?

Oct 6, 2008 | 04:59 PM

kenzo42

Thread Starter

Elite Member

iTrader: (6)

Joined: Sep 2007

Posts: 2,017

Total Cats: 13

From: CA

I should have mentioned I'm using stock 1.6 injectors and am bone stock.

Oct 6, 2008 | 05:14 PM

Joe Perez

Boost Pope

iTrader: (8)

Joined: Sep 2005

Posts: 34,402

Total Cats: 7,523

From: Chicago. (The less-murder part.)

In that case, the DIY maps are the closest y'all are going to get.

When transitioning from standard to HR, some re-tweaking of the VE table is necessary, however it's not like the car isn't going to run. As long as you've got a WBO2 sensor and have EGO figured out, you can start with the DIY base maps and let the system fine-tune them for you.