EBC and Idle
#1
Senior Member
Thread Starter
iTrader: (6)
Join Date: Jul 2007
Location: Cocoa Beach, FL
Posts: 850
Total Cats: 16
EBC and Idle
I've never been able to get my idle to work right and at some point my boost control just stopped working. I just got a new MS chip thinking it may have been the problem. I replaced it and still no good. I did realize something on the boost, though. It works when the car is off, but the second I turn it on, it stops. I set everything to 100 duty cycle to check it and the light turns on when the car is off, but it turns off when the car is on. I set it to 50 to see if it would click and it did while the car was off.
Has anyone had luck with EBC or idle with HR_10g? I'm thinking of going back to the standard MSnSE to see if it works.
Has anyone had luck with EBC or idle with HR_10g? I'm thinking of going back to the standard MSnSE to see if it works.
#2
Senior Member
Thread Starter
iTrader: (6)
Join Date: Jul 2007
Location: Cocoa Beach, FL
Posts: 850
Total Cats: 16
OK, I've narrowed it down a little more:
I installed an easythermed version of 029y4 and loaded my MSQ. Boost was working until I turned the car on, then it no longer worked, even if I loaded my MSQ again and turned the car off/on. I reloaded the firmware and loaded the MSQ and it worked again until I started the car again. It looks like there's a memory leak somewhere. I even installed the megatune version supplied with 029y4 to make sure it wasn't anything in my megatune configuration. I guess I should burn the firmware without easytherm and see if it does what it's supposed to minus the screwed up temp sensors.
I installed an easythermed version of 029y4 and loaded my MSQ. Boost was working until I turned the car on, then it no longer worked, even if I loaded my MSQ again and turned the car off/on. I reloaded the firmware and loaded the MSQ and it worked again until I started the car again. It looks like there's a memory leak somewhere. I even installed the megatune version supplied with 029y4 to make sure it wasn't anything in my megatune configuration. I guess I should burn the firmware without easytherm and see if it does what it's supposed to minus the screwed up temp sensors.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM