Hi, i was looking on threads for info but i can't find anything about how to set ID725 parameters like opening time, cranking pw and so on, i am using a rev eMS2 with sequential wiring on my 1.6, thank you for help

 

Whats your email? I can send you my flowforce 630 settings.
Opening time should be close to the flowforce which is 0.63ms
In my experience the ev14 injectors require lots of fuel for idle. I rescaled my req fuel and the added around 20 points to the ve table on the idle cells.

 

The technical information can be found on ID's website. Stuff like dead time and whatnot.

For a baseline so it will run, just input the info into MS fuel settings. You know, engine size and injector size, plus seq or batch or whatever. Your tuning will do the rest.

Cranking fuel should carry over.

Edit: oh and I'm sure Rev is a busy guy but he could probably give you some insight as well since you're a customer

And check this out, might be useful plus you can contact them directly and they might make something like it for the 725's

http://help.injectordynamics.com/sup...942-megasquirt

 

Found some advise over the net, i'm sorting out it, thanks everyone 👍🏼

 

this took like 1.5 seconds to search:

https://www.miataturbo.net/megasquir...ynamics-81448/