Injector resistor pack
Thread Starter
Elite Member
iTrader: (24)
Joined: Jun 2007
Posts: 4,667
Total Cats: 18
From: Woodland Hills, CA
well, i got that. but do i need to change any seetings in megasquirt to make sure it knows that im running low impedance injectors?
i can always try speaking to it but i dont think it will help :/
i can always try speaking to it but i dont think it will help :/
Reply
0
0
Joined: Sep 2005
Posts: 34,402
Total Cats: 7,523
From: Chicago. (The less-murder part.)
The exact settings will differ for different injectors, but here's the writeup on tuning them: http://www.megamanual.com/v22manual/mtune.htm#pwm
Reply
0
0
Supporting Vendor
Joined: Sep 2006
Posts: 2,332
Total Cats: 67
If you're running high-res code (which the '96-'97 MSPNP models run), you cannot use PWM current limiting. The standard code supports this, but it was removed for the hi-res code to make room for more pulse width control.
Reply
0
0
Newb
Joined: Mar 2008
Posts: 20
Total Cats: 0
so basically, running MS pnp with low-imp injectors...
You utilize MS PWM to configure the injectors to run as low-imp
and quoted from joe perez...
"run a pair of heavy (16 ga or so) wires directly from the ground side of R37/R38 to a dedicated ground."
after you run the 16 ga wire w/configuring MS PWM you should be set on running low-imp injectors?
Just wondering if I left a step out
Thanx a bunch joe, you knowledge is much appreciated
You utilize MS PWM to configure the injectors to run as low-imp
and quoted from joe perez...
"run a pair of heavy (16 ga or so) wires directly from the ground side of R37/R38 to a dedicated ground."
after you run the 16 ga wire w/configuring MS PWM you should be set on running low-imp injectors?
Just wondering if I left a step out
Thanx a bunch joe, you knowledge is much appreciated
Last edited by malachi_fox; Apr 28, 2009 at 04:34 AM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
