kingofl33t on ebay!
#3
Elite Member
Thread Starter
iTrader: (5)
Join Date: Sep 2006
Location: Marietta, GA
Posts: 2,195
Total Cats: 1
I may go MS before going turbo. That might save some time later, as the eventual plan is to MS it anyway. I could be playing around with NA tuning while accumulating turbo bits. Hmmm...I might like that...
#12
Well, I need to see what it goes for. I'm trying to see what a fair price of a complete unit is worth. I figure ebay would be a good form of market research. If it sells for 450.00 I don't plan on offering it as a complete unit like this again. If it does 550.00 or better I'll probably start offering a complete kit. At 450.00 I barely cover my expenses for the MS, AIT sensor,
tubing, and wire.
If it does end up at 450.00 I'll probably just keep with you buy everything send me your MS and ECU and for 120.00/140.00 I'll do the mods.
99's are coming soon I just need some free time. I really don't like adding the 90-97 CAS. I'm going to get some help from a EE and see if we can make a
conditioning circuit so I can fire off the stock sensors.
tubing, and wire.
If it does end up at 450.00 I'll probably just keep with you buy everything send me your MS and ECU and for 120.00/140.00 I'll do the mods.
99's are coming soon I just need some free time. I really don't like adding the 90-97 CAS. I'm going to get some help from a EE and see if we can make a
conditioning circuit so I can fire off the stock sensors.
#18
The MS will handle pretty much anyinjectors as long as they are high imp or your run resistors. The stock wiring has trouble with low-z injectors without resistors.
The reason you usually have trouble with a piggy back is they can't adjust the quanity of fuel at idle. It doesn't have anything to do with the ilde control valve.
The reason you usually have trouble with a piggy back is they can't adjust the quanity of fuel at idle. It doesn't have anything to do with the ilde control valve.
Last edited by kingofl337; 10-25-2006 at 08:51 AM.
#20
Please excuse my stupidititty, but to get this straight in my feable mind, this takes the place of an FMU, bipes, o2 clamp, and afm?
Also, do I also need a map sensor or is this built in?
Will it work with stock 1.6 injectors or should I not bother and go right to the 1.8s? (I only plan to run 8or 9 psi when I get my intercooler going)
Also, do I also need a map sensor or is this built in?
Will it work with stock 1.6 injectors or should I not bother and go right to the 1.8s? (I only plan to run 8or 9 psi when I get my intercooler going)