MS3 Basic '99 - looking for HOT (+12)
10-18-2013, 07:07 AM
#1
Retired Mech Design Engr
Thread Starter
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 857
MS3 Basic '99 - looking for HOT (+12)
I have a Reverant MS3 Basic. Is there a +12V (not switched) available on the DB37? I want to run it to my Innovate G5 gauge.
Reply
0
0
10-18-2013, 09:39 AM
#4
Retired Mech Design Engr
Thread Starter
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 857
Thanks. Rev, do you never sleep? A couple of other questions, while the DB37 loom is still out of the car:
1) What leads do I need to add to the DB37 to run sequential COP's? In other words, what pins go out to the other (2) ignition coils? These would be the Brown and the Brown & Green according to your instructions, but my loom does not have them. Would I also have to solder drivers to the PWB? If so, where?
2) Do you have a schematic or a full pin-out of the DB37?
3) What would I need, internally or externally, to utilize the digital output of the LC-2 as an input to the MS3? Or is there really any benefit over using the Analog?
My S/N is 12616
1) What leads do I need to add to the DB37 to run sequential COP's? In other words, what pins go out to the other (2) ignition coils? These would be the Brown and the Brown & Green according to your instructions, but my loom does not have them. Would I also have to solder drivers to the PWB? If so, where?
2) Do you have a schematic or a full pin-out of the DB37?
3) What would I need, internally or externally, to utilize the digital output of the LC-2 as an input to the MS3? Or is there really any benefit over using the Analog?
My S/N is 12616
Reply
0
0
10-18-2013, 12:30 PM
#5
Elite Member
iTrader: (10)
Join Date: Jun 2006
Location: Athens, Greece
Posts: 5,977
Total Cats: 356
You need the external wideband-to-CAN module, which should hopefully be available starting from next week.
Code:
Pin Function 1 Fused 12V 2 Ground 3 Sensor Ground 4 Wideband In 5 External MAP 6 Ign C 7 Ign D 8 CANH 9 CANL 10 RPM out 11 EXT_MAP Input 12 SPARE_ADC Input 13 PT2 Input 14 Tableswitch Input 16 EGO2 Input 19 Nitrous2 Output (3A Max) 20 EBC Output (PP3) 21 Ground 23 Nitrous In 36 VVT Output (5A Max)
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
