I just pulled the trigger on a ms3 diy kit and realized that it was going to be a little more difficult to install than i thought. I have been looking around for just a basic installation of wiring the ms3 into the stock miata harness. I found the ideal method is to run a db37 harness to a 64 pin connector. I'm now wondering which wires have to go where when connecting the two. Any assistance will be appreciated

 

Trubokitty.com will have all the info you need.

 

true story.

 

Awesome, exactly what i needed thanks! Can the installation be done without the 3X expansion card?

 

yes but my docs don't outline that--it would require building too many additional circuits.