No. I'm just trying to get it to idle, if I could get it to idle I would.

 

log even when you are trying to get it to idle.

 

Do you have the 1000cc injectors installed?
Do you have a vTPS installed?
Did you remove the STSIGN fuse?
Did you NOT rewire the injectors for sequential?

If yes to all of the above, I'll resend you the basemap that you should use.

 

yes to all but injectors.

 

How do I transfer a log onto the website?

 

Which of the two? Ie 190cc/1000cc or batch/sequential?

 

under submit reply there is manage attachments.
from there

 

Subscribe to the forum and use our uploader.

 

230 cc injectors, batch injection.

 

BTWs, I thank y'all so much. It means a lot that you'll help a douchebag like me.

 

Check your email, I just sent you a new basemap.

 

Just tried it. Still no luck. Do I have to be a member to upload maps?

 

Well, stupid me..... got it to finally sit and idle after it warmed up a bit..... bad throttle body gasket..... gonna swap it out and see if that helps.

 

Idles shittily, but stays running once warmed up. Bit of hesitation before revving.

 

Got a wideband in there? Have you connected a vacuum hose to the MAP sensor?

 

No wideband as of yet. I do have the vaccuum hose on though.

 

well you are gonna want to get a wideband, without its gonna be hard for you to do any tuning with it

 

I know. I didn't realize how useless the factory o2 sensor was lol.

 

its not useless, its just not accurate as you need it to be outside stoich. You could still try using it tune around stoich at idle right now if you wanted too.

 

Well, I just ordered a lc1 wideband.