MSPNP with no spark
ah, probably why it didn't sync, since I had to remove the ribbon to run the stim,
Then I'm going to conclude it was the output on d16 set to fan control. which is a spark output.
I guess I'll pull the resistor back out...just got finished packing the box up to mail back ...
Then I'm going to conclude it was the output on d16 set to fan control. which is a spark output.
I guess I'll pull the resistor back out...just got finished packing the box up to mail back ...
Reply
0
0
Thread Starter
Junior Member
Joined: Aug 2011
Posts: 120
Total Cats: 5
Yea I was holding down the key. How do I take a composite log? It was weird too cause it would crank for like 5 seconds, stop, crank for 5 seconds, stop even tho I was holding the key on. I just don't get it. I am beginning to think this ecu is just doomed.
Reply
0
0
what makes me wonder if reverant never swapped the coil outputs one he converted it to ms2. can you try swapped coils 1&4 with 2&3 and see what happens?
composite logs are done under the diagnostic tab.
composite logs are done under the diagnostic tab.
Reply
0
0
No! Don't swap coils. Use test mode to check for spark A on cyls 1 & 4 and spark B on cyls 2&3. If not, correct.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
