mspnp reset
#1
Senior Member
Thread Starter
iTrader: (7)
Join Date: Aug 2007
Location: Southern Indiana
Posts: 1,369
Total Cats: -1
mspnp reset
So, i installed my begi s1 with 460cc injectors and mspnp9495 and i drove it for the first time today. I was doing some tuning and the ms was resetting every couple minutes. I have attached the datalog. I did mess around with the grounds on my wideband but didnt disturb the ecu grounds. I have my wideband grounded with a second nut on the post between the valve cover and the TB.
#3
Resets are caused by bad grounding or bad 12v, you aren't experiencing comm resets so it has to be something else. You can tell it's not comm resets because the SecL counter resets back to zero whereas in a comm reset it would continue counting up after the reset.
Check your wiring. Just try grounding the wideband somewhere else for the heck of it.
Have you used vampire taps on any of the ECU wiring? They tend to damage the wire severly when used.
Check your wiring. Just try grounding the wideband somewhere else for the heck of it.
Have you used vampire taps on any of the ECU wiring? They tend to damage the wire severly when used.
#4
Senior Member
Thread Starter
iTrader: (7)
Join Date: Aug 2007
Location: Southern Indiana
Posts: 1,369
Total Cats: -1
The only vampire taps i have used are from the dash lights dimmer for gauge power. I haven't changed any grounds but i will clean them up a bit. Is there any way to tell how close my 12v is?
Thread
Thread Starter
Forum
Replies
Last Post
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM