Hi All,

I want some feedback on my MS2 build plan.
It is for a 91 with a 94 engine.

Here are a list of mods I am planning to do:
1) Use Abe's adapter board.
It will have the better Schmitt's trigger based input.
Will have switched power for my WBO2.
Will have the idle compensation for A/C
Better PWM idle drivers

2) Build Joe's better spark output with a PNP or a second NPN transistor.

3) Build fan control relay circuit.

4) Electronic boost control. ( This might be a later mod )

5) Mod the intake to fit the IAT sensor.

6) Bigger 305cc supra injectors (might run it at higher fule pressure)

7) I have a question about WBO2 setup.
Should I get a Innovate LC-1 or a JAW/NAW setup?
Anybody with JAW/NAW experience give some feedback?

Thanks in advance.
-Raj

 

I have the JAW working with my MS-II

The good: Works great, less expensive
The bad: Was a pain to calibrate, support is forum-based and tends to disappear for long periods, certain firmwares are rumored to have fried WBO2s.

 

I've got a JAW currently. It's pretty decent given the price and I really don't have any complaints about it. I wish it were easier to interface with the MS which is why I'm about to replace it with an LC1. But it's possible as mj71 said.

 

Thanks guys.
Mj71, that was my opinion too.

Rccote, what do you mean by wish it was easier to interface with MS?
Do you want to sell the JAW?

-Raj

 

I wish it were easier to get them to work together is what I meant, and yeah I'm probably going to sell it soon.