No spark when cranking with CBR coils, it sparks in test mode
Thread Starter
Junior Member
Joined: Mar 2011
Posts: 197
Total Cats: 19
From: Eindhoven, The netherlands
No spark when cranking with CBR coils, it sparks in test mode
So ive got some CBR coils wired up and now cant get it to start.
I tested all spark plugs in test mode and they all work. But when cranking it doesn't do anything
Im using MS3x (i think 3.57) and CBR coils with and Bosch 211 igniter
Spark A - cil1
Spark B - cil3
Spark C - cil4
Spark D - cil2
Ignition output - Falling edge
Spark output - Going high
Number of coils - Coil on plug
Spark hardware in use - MS3X spark
Cam input(if used) - MS3x Cam in
Ive added my tune and my datalog when cranking.
I tested all spark plugs in test mode and they all work. But when cranking it doesn't do anything
Im using MS3x (i think 3.57) and CBR coils with and Bosch 211 igniter
Spark A - cil1
Spark B - cil3
Spark C - cil4
Spark D - cil2
Ignition output - Falling edge
Spark output - Going high
Number of coils - Coil on plug
Spark hardware in use - MS3X spark
Cam input(if used) - MS3x Cam in
Ive added my tune and my datalog when cranking.
Reply
0
0
Thread Starter
Junior Member
Joined: Mar 2011
Posts: 197
Total Cats: 19
From: Eindhoven, The netherlands
Got it,
This site said it needed to on falling edge
Bosch 0 227 100 211 Ignition Control with MegaSquirt-II
but it i didnt change the CAS so it would still be rising edge.
This site said it needed to on falling edge
Bosch 0 227 100 211 Ignition Control with MegaSquirt-II
but it i didnt change the CAS so it would still be rising edge.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
Sep 12, 2016 08:17 PM
Greasyman
General Miata Chat
2
Sep 28, 2015 10:44 AM
