If I've installed everything and calibrated correctly, what should I see on the AFR gauge in the Tuner Studio panel at idle? It should pretty much be steady at around whatever AFR is in the table, correct?

I seem to be way rich and the needle sort of stutters.

Jon

 

you wont see the afr targets in the table untill you adjust the fuel table so that you hit that target.

 

I don't quite understand that.

I have the AF gauge added to the virtual instrument cluster and am reading off of that. I'd expect it to match roughly what is in the AFR target table. I can look at both the forced target table and the VEAnalyze Live AFR table to see the target.

I don't think the LC1 is giving the correct readings as using VEAL was making it run worse and completely different from what I was getting with the stock 02 sensor. The table was altered pretty drastically.

I'm going to try calibrating again, as I might not have let the sensor warm up long enough.

 

my LC-1 sometimes decides to output weird numbers that make no sense for conditions or sweeps from 12:1 to 16:1 at idle with o2 corrections on (target table is 14.0:1) and set down to 500rpm... try cycling the key a few times...it sometimes fixes it for me

 

I'll give it a shot. Thnx

 

I didn't know you couldn't calibrate with a PC attached, or that you had to off/on the car to get the LC1 out of programming mode. Why this isn't in the manual, I don't know. Working great now!