New injector PWM settings...
#1
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
New injector PWM settings...
So this morning I swapped in my 460's. The only thing I changed was my required fuel setting. The car started fine, and I VE analyzed it one time, and everything looks good. I was reading the Megamanual and it says this:
----------------------------------------------------------
If you are running high-impedance injectors (greater than 10 Ohms), then set the:
PWM Time Threshold to 25.4 msec, and the
PWM Current Limit (%) to 100%.
(The presence or absence of the active flyback circuit (v3) or flyback board (v2.2) doesn't matter for high impedance injectors.)
If you have low impedance injectors (less than 4 Ohms), set the:
PWM Time Threshold to 1.0 msec, and
PWM Current Limit to 30% in most cases (all V3 main board with active flyback installed, and all V2.2 main board with flyback daughter board installed).
Set the initial PWM% to 75% if (and only if) you have low impedance injectors and have NOT installed:
the active flyback circuit on a V3 main board (assembly manual step #69), or
the 'Flyback Board' daughter card on a V2.2 main board).
------------------------------------------------
I'm pretty sure my RX-7 460's are low impedence, but according to my tune, it's set for high imp. What imp are the stock injectors? If I don't have my MS set correctly, why does it still run so well?
----------------------------------------------------------
If you are running high-impedance injectors (greater than 10 Ohms), then set the:
PWM Time Threshold to 25.4 msec, and the
PWM Current Limit (%) to 100%.
(The presence or absence of the active flyback circuit (v3) or flyback board (v2.2) doesn't matter for high impedance injectors.)
If you have low impedance injectors (less than 4 Ohms), set the:
PWM Time Threshold to 1.0 msec, and
PWM Current Limit to 30% in most cases (all V3 main board with active flyback installed, and all V2.2 main board with flyback daughter board installed).
Set the initial PWM% to 75% if (and only if) you have low impedance injectors and have NOT installed:
the active flyback circuit on a V3 main board (assembly manual step #69), or
the 'Flyback Board' daughter card on a V2.2 main board).
------------------------------------------------
I'm pretty sure my RX-7 460's are low impedence, but according to my tune, it's set for high imp. What imp are the stock injectors? If I don't have my MS set correctly, why does it still run so well?
#2
Senior Member
iTrader: (14)
Join Date: Aug 2008
Location: Tinley Park, IL
Posts: 1,482
Total Cats: 0
All the 460s I've ever seen were high impedance.
What's the denso number on the side of the injector. Cross refrence that to see what impedance they are. Or use a multimeter to check them. Maybe they are high impedance.
What's the denso number on the side of the injector. Cross refrence that to see what impedance they are. Or use a multimeter to check them. Maybe they are high impedance.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM