Hi guys. i have been building by stim for the last few hours and i am almost done. i need a new tip for my iron so i will finish probably tomorow.
my soldering skills... welll lets just say i dont have any. really hope it works ok though.
not sure if this stim will work since this is the 1.3 version.
another thing, i was bending the lead on q1, in the 1.3 directions. the middle lead broke. on the package it says trans. npn 200 ma to -92. can i pick this up at frys or radio shack? what do i need to tell them? how much will it cost? thanks alot and here are the pics. maybe you guys can give some pointers with my soldering.
thanks alot!

 

Anyone?!

 

You need a part number, I dont see it being more then a couple bucks but I have no idea. On a side note I got some completely unrelated transisters on ebay for 8 cents each.

 

Wait I need a part number? Would the store have its own part number? Where would I get the number? I still have the bag that the component came in that has the description on it.. Will that be enough?
Thanks!
Any more info/help/advice?

 

That should be. Bring the component also. It really all depends on how good the reps are at the store.
--Alex

 

http://www.jbperf.com/JimStim/jimstim-bom_v1_3.xls

This I believe is the stim parts list.

 

ok thanks alot guys... i did have the part number on the baggy from diy. i whent to radio shack and they had the part! i finished the stim and started on the actual ms build!!! thanks to everyone for the help!