table switch (or launch) without daughterboard modification?
04-23-2014, 06:46 AM
#1
Senior Member
Thread Starter
Join Date: Nov 2007
Location: Belgium
Posts: 999
Total Cats: 73
table switch (or launch) without daughterboard modification?
I seem to remember reading that it's no longer needed to modify the ms2 board to do table switching (or was it launch control)?
Been looking for info on this on MSExtra as well as here, but I can't find any info on it.
Was I dreaming or is the mod indeed no longer needed?
The launch modification isn't really a problem but TS has always been a pain to do.
Been looking for info on this on MSExtra as well as here, but I can't find any info on it.
Was I dreaming or is the mod indeed no longer needed?
The launch modification isn't really a problem but TS has always been a pain to do.
Reply
0
0
04-23-2014, 09:06 AM
#3
Supporting Vendor
Join Date: Sep 2006
Posts: 2,332
Total Cats: 67
Table switching (PE1) needs mods; there are several launch pins that don't:
MS2-Extra Hardware Manual
MS2-Extra Hardware Manual
Reply
0
0
04-25-2014, 12:29 AM
#5
I asked the same question in almost the exact same way over at msextra:
Megasquirt MSEXTRA / MS3EFI • Table switching - was I dreaming? (View topic)
Megasquirt MSEXTRA / MS3EFI • Table switching - was I dreaming? (View topic)
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM
