Knock Detection for MS3
#1
Knock Detection for MS3
Hey guys,
So I've been looking at my knock gauge in the TS software (Gauge is called knock input)
And I've noticed that my knock never goes past 11-12 percent. Is that normal? I know that the factory knock sensor isn't that great, but I'd imagine I'd see much knock than that, just from engine noise alone.
My next question, is there a way for the CEL to illuminate when it triggers knock?
So I've been looking at my knock gauge in the TS software (Gauge is called knock input)
And I've noticed that my knock never goes past 11-12 percent. Is that normal? I know that the factory knock sensor isn't that great, but I'd imagine I'd see much knock than that, just from engine noise alone.
My next question, is there a way for the CEL to illuminate when it triggers knock?
Thread
Thread Starter
Forum
Replies
Last Post
FAB
Fab9 Tuning - Miata Performance Parts
21
06-08-2020 07:01 PM
Little Badger
Suspension, Brakes, Drivetrain
4
10-15-2015 12:18 PM
nick470
MEGAsquirt
0
10-05-2015 02:45 PM