Need a little help...

91
Stock everything
Brain built ms3x


Ok here's a little background from Weds to this morning..

Weds - Installed TPS, installed MS, got everything set-up per brains gravy train manual. Car fired up and ran beautifully.... Until I went full retard. I didn't have a timing light at my house, and got impatient. Decided to drive it around the block with VE analyze on, and my USB cable went to **** and lost connection mid-drive. Still seemed to drive ok after cable went and I made it the rest of the way around the block to my house. Tried to re-connect, but cable wasn't cooperating. Decided to attempt driving it as-is 5 miles to the store to grab a cable. Broke down a mile down the road. Thankfully I still had the stock ecu and TPS, so I swapped them back in and went on my way to get the cable. Decided to wait till tomorrow to dig into it again.

Thursday - Tinkered around with it in the garage... Re-installed TPS and MS. Nothing groundbreaking... Still no start.

Today - Found out how to restore to original tune via back-up files... Flashed 1st back-up file and started from the beginning. Re-calibrated everything and set it all up per brains instructions again. Still crank no start situation. With a little throttle I can get it to run but it mis-fires and runs like ****.

Sooo where do I go from here? Will getting a log help or anything? I'm not even sure I know how yet cause I haven't gotten that far but im sure I could figure it out.

 

Is your MAP line pinched?

 

Could I get a copy of the setup manual? I just got a box with MS3 and cables.

 

Just checked... Didn't seem to be but I cut another piece of vacuum line and ran it through the window and tried again. Still nothing.

 

I'll see if I can find the file in my email. I've been using a copy I printed back in November lol

 

Weren't you having issues with TPS wiring/calibration? You're sure that's all resolved?

 

Yup switched the wires and got the correct readings. Everything is calibrated properly right now.

 

So are you running with AFM or no?

 

I also keep having this happen...

 

Nope go iat

 

youre using the onboard usb connector?

 

I'm using a 2.0 USB cable. Brand new belkin cable

 

I just thought I had some progress but it was just messing with me.... I had it running for about 10 seconds but stalled out again

 

did you log it so we can actually see why it stalled?

 

Of course not... But I got it to happen twice so I will start a log and try again until it happens.

Sooo now I have to figure out how to do a log and post it on here. Ill post back when I get it

 

Ok got one. How should I host it and put it in here?

 

Hopefully the log attached works...

 

looks like you posted a composite log, now how about a normal datalog?

 

I'm glad I'm not the only one that made this mistake. That damned tab!

 

Oops... Lets try this one...