Using EasyTherm5 with the hr_10g
#1
Using EasyTherm5 with the hr_10g
Hi there again!
I know I just opened another thread, but since this is on a different subject, I post it in a separate thread as it might help other people...
I don't currently have a GM IAT sensor, but since I have lots of other temp sensors lying around, I thought I'd use a Bosch sensor as an IAT. I have a datasheet for this sensor with lots of resistor values to choose from, to build the three-point curve using EasyTherm5. I also downloaded a fresh version of the hr_10g firmware (is there any reason I should use a newer one?).
Now there are two questions. The first one is, I have the data for the IAT sensor, but what do I use for the CLT sensor data? I'm using the standard sensor on my '91 NA for CLT. I reckon EasyTherm5 always defaults the sensors to GM sensors, no matter what project I choose to open, so I need to know what CLT sensor the Miata uses.
Also, how do I flash this fixed firmware to my Megasquirt?
Cheers and thanks in advance!
I know I just opened another thread, but since this is on a different subject, I post it in a separate thread as it might help other people...
I don't currently have a GM IAT sensor, but since I have lots of other temp sensors lying around, I thought I'd use a Bosch sensor as an IAT. I have a datasheet for this sensor with lots of resistor values to choose from, to build the three-point curve using EasyTherm5. I also downloaded a fresh version of the hr_10g firmware (is there any reason I should use a newer one?).
Now there are two questions. The first one is, I have the data for the IAT sensor, but what do I use for the CLT sensor data? I'm using the standard sensor on my '91 NA for CLT. I reckon EasyTherm5 always defaults the sensors to GM sensors, no matter what project I choose to open, so I need to know what CLT sensor the Miata uses.
Also, how do I flash this fixed firmware to my Megasquirt?
Cheers and thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post
jnshk
MEGAsquirt
2
09-29-2011 08:11 PM