Using Ultragauge with MS3 Basic and OBD2 module
08-12-2017, 04:12 PM
#1
Newb
Thread Starter
Join Date: Aug 2016
Posts: 4
Total Cats: 0
Using Ultragauge with MS3 Basic and OBD2 module
Just bought an Ultragauge, picked it over Scangauge due to the size. But I can't get it to work with the ECU and OBD module Rev built. Rev said he doesn't know much about the Ultragauge so I'm kind of on my own here. Changing CAN/OBD setting in TurnerStudio doesn't seem to help. My wideband goes through the CAN module as well, so at least I know wiring was go and that oart of the module works. Any body here use Ultragauge and got it working? Settings in TurnerStudio?
I'd like to give it a good shot before I get the Scangauge.
I'd like to give it a good shot before I get the Scangauge.
Reply
0
0
12-31-2018, 08:16 PM
#2
Newb
Join Date: Jun 2014
Location: San Jose, CA
Posts: 17
Total Cats: 7
Reviving this thread because I'm encountering the same issue. On my ultragauge, it'll display "11-bit can found" for a few seconds before displaying "comm lost, restarting".
Were you ever able to get your ultragauge to work with rev's ms3 basic?
Were you ever able to get your ultragauge to work with rev's ms3 basic?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
