I built a 2k pull-up on my VSS signal, how can I view this a speed in Tuner Studio on a MSPNP2? I have it wired to Table Switch, Firmware Version 3.4.2. I don't think MS uses VSS in PNP2 for anything, but I'm hoping there is still a way to pull out the speed and have it available in the dashboard or CAN without upgrading to MS3. I don't have the "Advanced Engine" settings, so I can't tell Tuner Studio how to detect gears/speed. I assume this is related to MS2 VS MS3.

 

The MS2 doesn't know what VSS is, you do need an MS3 for that.

 

@AidanDJ has a thread/ posts talking about using a board from jbperf (I think) to capture speed and input it to MS, was working on getting it to his dash, IIRC

 

That is the JBPerf conditioner board to change ABS signals into something a MS3 can read. It won't help him with a MS2.

 

Alright, time to list my PNP2 and stock ECU.

 

IF you datalog using TS on an android device, then it will capture a Speed channel from the GPS on that device. That signal is dependent on the accuracy and sample rate of the GPS and can be quite crude, but it better'n nothing! I did that a long time ago to try to get 0-60 times, but the signal was so crude that I had to put the data into Excel and interpolate in order to get anything semi-meaningful.