curly

iTrader: (25)

I'm trying to setup one of Rev's wideband modules with his MS3 basic, can someone spoon feed me the settings? I've followed the instructions including wiring and setup, but can't get it to communicate with the laptop.

curly

iTrader: (25)

Aidan says the project properties are important too...

aidandj

iTrader: (5)

If you are able to change settings on the wideband module then you are getting a connection. What is the AFR reporting?

You also need to change Fuel Settings->AFR/EGO Control-> EGO ports to CAN EGO.

aidandj

iTrader: (5)

Set the Device ID in the project properties to 9.



Also. post tune.

curly

iTrader: (25)

AEM is reading full lean, TS gauge reads 7.4

dleavitt

iTrader: (1)

I had a little trouble when setting it up the first time too. I don't know what exactly I did different, but after going through the steps a few times it ended up working.

dleavitt

iTrader: (1)

This, I had trouble getting that to stick for some reason.

curly

iTrader: (25)

This is what I get when I do that.

aidandj

iTrader: (5)

Ok. Then the instructions need to be updated if its shipping as CAN device 1.

@Reverant

aidandj

iTrader: (5)

You also need to change Fuel Settings->AFR/EGO Control-> EGO ports to CAN EGO.

This might fix that.

dleavitt

iTrader: (1)

I am 99% sure it was 9 when I installed it originally (This is my car he's working on). Unfortunately my laptop is at home so I can't confirm on my copy of the old tune.

curly

iTrader: (25)

EGO 1 Port is already set to CAN EGO, lambda averaging lag is set to 100, and Innovate EGO data is set to 9,0,0 as per the instructions.

aidandj

iTrader: (5)

Ah. If the device ID isn't 9 anymore then this needs to be 1.

curly

iTrader: (25)

Still gives me the same error if I set everything to 1 instead of 9.

aidandj

iTrader: (5)

The protocol error?

curly

iTrader: (25)

Yes, that it's communicatiing with my device but not at the assigned CAN id

aidandj

iTrader: (5)

This sounds like the same error @vteckiller2000 was having.

But he never fixed it.

You can use a utility called port scanner to test devices, and see what each CAN id is.

Megasquirt Support Forum (MSEXTRA) ? Port scanner (View topic)

curly

iTrader: (25)

Port scanner is coming up with "unknown device" for CAN ID 0-14.

aidandj

iTrader: (5)

Thats not right. CAN ID 0 should at least be showing up as the MS3.

Can you post the tune?

dleavitt

iTrader: (1)

Hopefully Rev can chime in. CAN module was working back in January, so it shouldn't be a hardware problem.