Has anyone done a back to back with a square top?

D


Poss in for a set

 

I plan to get a baseline dyno on mine whenever i get it swapped in. 03 VVT rods only with this intake manifold, ebay 4-1 header and ms3x.

 

Nicely done! If I were anywhere close to needing something like this I would be all over this deal. My build is very mild and low boost though.

 

I had been searching the web for an intake solution for my mazda (its an 808 coupe same as rx3 coupe shape with space restrictions) which will be running an NA engine and came upon this thread, so i contacted Mike
and he made up an na flange, throttle body adaptor,cable bracket and support brace so i can run the honda manifold, then shipped over to me in Australia. He was really quick in getting this done,
if you are looking to go in this direction i would recommend Mike, absolutely no fuss.

Matt

 

Any updates on this? Keen for results.

 

Also interested. This would be a great setup to move to a skunk 2 throttle body correct? I'm curious on the dyno numbers as well if anyone can test it.

 

Received mine from mike today. Couldnt ask for better customer service. Looks great and is surprisingly light. Cant wait to weigh it against my stock 99 mani. Thanks mike!!

 

Thanks for the kind words Reed!

 

 

why not just buy a skunk manifold to fit a miata?

 

They are a little bit different things since some people are looking for a diy part that they can say they made themselves. It's also a bit cheaper if you do the welding yourself.

From the performance side (this is me speaking with no data to back me up) you do get a runner with no bends and a straight shot right into the port. You also get the ability to run a honda throttle body in any available size, 70mm or bigger for pretty cheap. Also no fittment issues (doeant hit the starter...).

An aside, the s2 miata manifold is bored to 64mm to work with their 64mm tb. I found that a 64mm bore exposes all of the iac passages on a stock mazda tb. Does that do wonky things to the idle?

 

Can I purchase a manifold still?

 

what do you do about injectors?

 

Why would injectors be affected? It looks like the flange clears the injectors. Btw, i've never seen anybody with an almost 1:2 post:neg cat ratio.

 

Oh i guess I did not know the head the has injector cast into them....