Leaky Trackspeed radiator
#1
Elite Member
Thread Starter
iTrader: (24)
Join Date: Jun 2007
Location: Woodland Hills, CA
Posts: 4,667
Total Cats: 18
Leaky Trackspeed radiator
This radiator came with my MSM. It was working amazing until last track event where I've discovered a small leak under a weld near the cap.
I've used my spare Godspeed to replace this as I'm selling the car and I don't need an NB radiator, so I never bothered fixing it. It also comes with an OEM fan from MSM. Use it or junk it - I don't care.
$300 cash, picked up from North Hollywood, CA or $350 shipped CONUS.
Arrow points to where the leak is coming from
I've used my spare Godspeed to replace this as I'm selling the car and I don't need an NB radiator, so I never bothered fixing it. It also comes with an OEM fan from MSM. Use it or junk it - I don't care.
$300 cash, picked up from North Hollywood, CA or $350 shipped CONUS.
Arrow points to where the leak is coming from
Last edited by UrbanSoot; 02-10-2014 at 09:42 PM.
#7
Is it leaking from right at the corner or just on top a few MM from the edge?( I know your picture looks like its a few MM's away from the edge but I just want to confirm) Also is this an older generation TSE radiator that isn't a triple pass? (Not sure if TSE has always used a triple pass design) The picture of the radiator on TSE's website clearly shows welds 1/3 of the way down on the outside of the passenger side endtank and 2/3 the way down on the drivers side endtank segregating them for the triple pass.
Last edited by FrankB; 02-07-2014 at 09:32 PM.
#8
Elite Member
Thread Starter
iTrader: (24)
Join Date: Jun 2007
Location: Woodland Hills, CA
Posts: 4,667
Total Cats: 18
Is it leaking from right at the corner or just on top a few MM from the edge?( I know your picture looks like its a few MM's away from the edge but I just want to confirm) Also is this an older generation TSE radiator that isn't a triple pass? (Not sure if TSE has always used a triple pass design) The picture of the radiator on TSE's website clearly shows welds 1/3 of the way down on the outside of the passenger side endtank and 2/3 the way down on the drivers side endtank segregating them for the triple pass.
Thread
Thread Starter
Forum
Replies
Last Post