Trying to clean storage unit out so I can switch into smaller unit. I want all this crap gone ASAP. Located in Springfield, VA.

1.6 parts have around 95k and 1.8 parts have around 55k on them.

Braided Oil feed line - SOLD

1.8 Brake Booster - 25 + shipping

1.8 Starter - 30 + shipping

1.8 cruise control assembly - 20 + shipping



Turbo Catback exhaust with Cat welded in. Used in my 1.6 for a little less than 10k miles - 150 + shipping



38mm External wastegate w/ mounting flange - 50 + shipping

Passenger side turn signal assembly - 15 + shipping

1.8 Power steering pump - 20 + shipping

1.6 Fuel pump - 10 + shipping

Brake master cylinder - 20 + shipping

Wiper motor - 15 + shipping

Coolant reservoir - 15 + shipping

1.8 coil and wires (look brand new and never tested were on a wrecked miata w/ 55k I bought 9 months ago) prefer to sell locally so they can be tested prior - 25 + shipping



1.6 flywheel and flywheel bolts - 40 + shipping



Universal Coolant reservoir - 10 + shipping

Prosport Oil pressure gauge - green/white - 20 + shipping

BNIB Thermo hose sleeves - SOLD

Internal wastegate actuators from WRX td04 turbos - 10 each + shipping

Clutch Master cylinder (55k from a 95) - SOLD

Intake Filter - 10 + shipping



Center consoles - 20 each + shipping



99 Intake manifold with hoses, throttle body, egr block off plates, etc. - 100 + shipping

Variable Throttle position sensor (VTPS) - from a 95 ford v8, mounting plate included which lines up with a 1.6's tps mounting holes. - 30 + shipping




Front Lower Control Arms - 20 each + shipping


OE Jack - 10 + shipping

Evap Canister - 10 + shipping

OE Jack - 10 + shipping

Rear Lower Control arms - 20 each + shipping

 

1. I can't tell much from the pictures, so could you please elaborate on the braided oil line for $10. I'm looking for one that will go from the oil feed location on the 90-95 blocks and will attach to my T25 turbo. It's tough to tell, but it looks like one end is a 90* to -4an? and the other end has male threads of some sort.

2. What are the thermo-sleeves sized for? Are they sized for the turbo oil/water lines or are they larger in diameter?

 

what kind of external wastegate is it?

 

Ill have to find and measure the oil feed line. Ill let you know.

The thermosleeves would fit hoses up to 3/4in. I should double check though... probably should have done this prior to posting, sorry.

Ebay special 38mm.

 

Is the cruise stuff all there my R doesn't have it at all

 

Thanks for the update.

 

what muffler was used with the exhaust? also what size is the piping?

 

Just whats in the picture is what I intended on selling. I still have the cruise switch installed in my car (but do not use) I could pull it if thats what you need. LMK.

2.5" ID. Dynomax Turbo muffler IIRC.

 

I'm looking to get the whole cruise setup with wiring and all

 

bump