Long runner intake manifold 1.6 custom
Thread Starter
Senior Member
iTrader: (12)
Joined: May 2008
Posts: 849
Total Cats: -34
From: Roselle, Illinois
Long runner intake manifold 1.6 custom
I have a Honda manifold that has been modified to fit a 1.6 miata. This was adapted using a miata flange welded to the honda runners. I purchased this off another MT member. It has a honda throttle body. The tps sensor was cracked off so it will need a tps sensor. There are no provisions for a IAC valve, there is a hole that was welded shut that could be drilled and tapped for a hose to run to a iac solonoid? You would use your stock fuel rail with this set up. I was really hoping to use this manifold but the runners are just to long! Im building a front wheel drive festiva. I had 2 options cut the runners or cut my fire wall. Before i hack up this intake i decided to see if anyone would be interested in buying it and i will go a different route. Im looking to get 300 + shipping
pictures of intake
pictures of intake
0
Thread Starter
Senior Member
iTrader: (12)
Joined: May 2008
Posts: 849
Total Cats: -34
From: Roselle, Illinois
i picked it up from Kotomile which i think levnubhin has it made? you can find more info here
https://www.miataturbo.net/build-thr...d-45958/page8/
https://www.miataturbo.net/engine-pe...-43103/page18/
https://www.miataturbo.net/build-thr...d-45958/page8/
https://www.miataturbo.net/engine-pe...-43103/page18/
Last edited by Hot_Wheels; Nov 29, 2012 at 02:34 AM.
0
Thread Starter
Senior Member
iTrader: (12)
Joined: May 2008
Posts: 849
Total Cats: -34
From: Roselle, Illinois
0
Thread
Thread Starter
Forum
Replies
Last Post
