This is a pretty much brand new megasquirt 2 3.57 board, plus a 24" wiring harness, a tuning cable, an electronic boost control solenoid, and a female plug which plugs into the stock wiring harness allowing you to make this a PNP unit. The board has had the modifications described in the "how to megasquirt your miata" article.

I never was able to get an RPM signal with this, though I'm 99% sure the issue was in my wiring from the harness to the female plug. Nevertheless, I'm selling this as-is and you may need to redo some of the modifications I made. You will definitely have to redo the wiring to fit your application. I finally gave up and bought a MSPNP so I just need to sell this one. The price for all these parts new was close to $600, I'm selling for $450 shipped.

 

buzzump

 

bumpty dumpty sat on a wall

$400 shipped
$375 without EBC solenoid

 

Do you still have this ?

 

Yes i do!

 

bump

 

about the mega S
redo some of the modifications I made? what part did you mod?
thanks ian

 

Will you sell the EBC seperate? I think I can pick it up in person.

 

Yeah I'm willing to do that. I can meet either in Livermore or berkeley. Pm me

 

It's in the "how to megasquirt your miata" article. Just a couple resistors/jumper wires added to set it up to control the miatas electronics. You'll need to read that article if you're planning to install this anyway.

 

Thanks for the direction
i dont think this is the project for me
icarp