Megasquirt 2 3.57, wiring harness, tuning cable, and EBC solenoid
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Livermore, CA
Posts: 138
Total Cats: -18
Megasquirt 2 3.57, wiring harness, tuning cable, and EBC solenoid
This is a pretty much brand new megasquirt 2 3.57 board, plus a 24" wiring harness, a tuning cable, an electronic boost control solenoid, and a female plug which plugs into the stock wiring harness allowing you to make this a PNP unit. The board has had the modifications described in the "how to megasquirt your miata" article.
I never was able to get an RPM signal with this, though I'm 99% sure the issue was in my wiring from the harness to the female plug. Nevertheless, I'm selling this as-is and you may need to redo some of the modifications I made. You will definitely have to redo the wiring to fit your application. I finally gave up and bought a MSPNP so I just need to sell this one. The price for all these parts new was close to $600, I'm selling for $450 shipped.
I never was able to get an RPM signal with this, though I'm 99% sure the issue was in my wiring from the harness to the female plug. Nevertheless, I'm selling this as-is and you may need to redo some of the modifications I made. You will definitely have to redo the wiring to fit your application. I finally gave up and bought a MSPNP so I just need to sell this one. The price for all these parts new was close to $600, I'm selling for $450 shipped.
#10
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2013
Location: Livermore, CA
Posts: 138
Total Cats: -18
It's in the "how to megasquirt your miata" article. Just a couple resistors/jumper wires added to set it up to control the miatas electronics. You'll need to read that article if you're planning to install this anyway.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM