psyber_0ptix

iTrader: (4)

Updated. The whole thing needs to shift forward a quarter inch or so for the hole to align but interferes at the backside. Not a big deal, i can mod it and use a washer if needed. Just wasn't sure.

Just gotta mod and fit before powder coat

aidandj

iTrader: (5)

The slotted hole in the back is to accommodate the 1.6 valve cover. So on the VVT the bolt should be towards the rear of the slot.

psyber_0ptix

iTrader: (4)

I'll try to shave the slotted rear to see if I can sneak it forward more, but it may just need to be cut + washer. I should have shaved the valve cover before coating.

TheBandit

iTrader: (8)

Boots look good! I'm slightly partial to my bracket, but I'm glad we're getting some options out there!

hi_im_sean

iTrader: (3)

The timing was funny wasn't it? Thanks Mike!

TheBandit

iTrader: (8)

The timing was quite funny indeed. As long as we're expanding the market and capabilities of these cars I think it's a great thing. Keep it up!

psyber_0ptix

iTrader: (4)

Is there a way to pull the terminals deeper into the boot? The seals push into the holes of the valve cover only about a third or at best half way in.

aidandj

iTrader: (5)

You have the black VVT wires right? Not the blue 90-00.

psyber_0ptix

iTrader: (4)

Black ones. So sexy. They just don't slip down all the way. The terminal for the sparkplug is a little too close to the opening

hi_im_sean

iTrader: (3)

You can pull on the wire while at the same time pushing the terminal into the boot. The boot grips the wire much tighter than it grips the terminal. It may take a bit of force.

psyber_0ptix

iTrader: (4)

Will try tomorrow, thanks!

Quite the quality kit, it installed easy peasy.

aidandj

iTrader: (5)

Get us pics as soon as you can!

psyber_0ptix

iTrader: (4)

Like real pictures? I'll take some with camera tomorrow
I need to rewire, my plug wires are all crisscross.

I only have janky phone pic for now

psyber_0ptix

iTrader: (4)

I made a booboo, can I order another set of wires?

hi_im_sean

iTrader: (3)

Lol, what did you do? Just send them back and ill fix em. Sounds like I may have set your terminal depth a little off anyway.

etang789

will this bracket interfer with the Carbing 3 point strut bar?

aidandj

iTrader: (5)

Most likely. But if you measure how far the strut bar is from the engine we can be sure.

etang789

Do you make the Plug N Play wiring harness as well?

aidandj

iTrader: (5)

We do not.

farpolemiddle

I have a gm harness I can send you for $20. Plugs into the 585s. You would just need to change out the main gm connector.