Launch control/flatshift wiring to mspnp2.
#1
Launch control/flatshift wiring to mspnp2.
So I'm looking for info on some wiring to set up flatshift/ launch control. I haven't really heard just one straight answer... I've heard people use the flex port or the input 1 or 2 wondering what's the best. I have mspnp2 and a 94 Miata. I know to ground a switch to have capabilities of shutting these off and on. Also I've heard people saying to use the top clutch switch over the bottom switch. Is one better than the other? What color is the wire I need to tap into? A wireing schematic would be appreciated if possible thanks.
#2
Senior Member
iTrader: (1)
Join Date: Dec 2010
Location: Farmington Hills, MI
Posts: 1,218
Total Cats: 175
MegaSquirtPNP by DIYAutoTune.com
This says it should already be wired, just needs the jumper in the correct position. Pretty sure the input is called "launch". Flex, input 1 and input 2 are likely referring to a DIYPNP. You would use the top switch, the bottom switch is the starter disconnect. Google "94 miata wiring diagram" for a schematic.
This says it should already be wired, just needs the jumper in the correct position. Pretty sure the input is called "launch". Flex, input 1 and input 2 are likely referring to a DIYPNP. You would use the top switch, the bottom switch is the starter disconnect. Google "94 miata wiring diagram" for a schematic.
#5
Would this be the same for a ms3pro pnp
#10
Putting the switch inline means that launch control is activated by the clutch switch when the switch is closed and disengaged when the switch is open.
Also, keep in mind that the combination of foot on the clutch, open throttle, and engine being revved past the launch rev limiter isn't something you will encounter very often in normal driving.
Also, keep in mind that the combination of foot on the clutch, open throttle, and engine being revved past the launch rev limiter isn't something you will encounter very often in normal driving.
#11
MS3 PRO pnp in to an Exocet Miata 2003
Can't get Launch control to work, I've tried a ton of different things but I'm not getting anywhere. Launch control is wired to the "N" in the options plug and ran to the Clutch Switch and tied in (5v). In TunerStudio "Digital IN 2" is selected with the other settings made. What could I be missing?
Can't get Launch control to work, I've tried a ton of different things but I'm not getting anywhere. Launch control is wired to the "N" in the options plug and ran to the Clutch Switch and tied in (5v). In TunerStudio "Digital IN 2" is selected with the other settings made. What could I be missing?
Thread
Thread Starter
Forum
Replies
Last Post