Last night driving home from work, I was autotuning with my MSPNP Gen 1 and my car (92 Turbo listed in my signature) just randomly shut off. I immediately pulled out my laptop and tunerstudios wouldn't connect. so I tried Megatune only to get the following error message:

Controller code version does not match signature in MsnS-extra.ini.

(See audit.log for where the above file was found.)

Expected “MsnS-extra format 029q *********” (found in ini file)
received “” (from controller)

Table corruption may occur, this is usually a very serious problem.

The red lights in the case no longer light up and the car will not start back up. Did my MSPNP fry itself? :( I have not pulled the case off for fear of voiding any possible warranty i might have.

 

TTT I need this car back up and running. I put an email in to DIY Autotune hopefully they can help me out.

 

youll have to try to reflash it... but it appears to be getting power, but cupported its firmware.

 

I tried to reload the firmware yesterday but got the attached error message.

 

just got an email back from Matt at DIY and he said to try jumping the 2 "Boot" pins and reloading the firmware as if I were upgrading from standard code. I'm going to try this after work. One thing I will say, even if this doesn't work, DIY has been great about getting back to me in a reasonable amount of time. first email took less than 24 hours, second email was less than 3... very impressed with the customer service so far.

 

yeah boot jumper must be used.

 

Did you not install the boot jumper?