MSPNP just installed, car won't idle on basemaps, please help!
#21
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
Does the car run normally on the stock ECU?
You say you are running without an AFM. Did you load the without AFM firmware to the MSPNP ECU (with the ignitor disconnected)?
Have you checked and set your timing?
You say you are running without an AFM. Did you load the without AFM firmware to the MSPNP ECU (with the ignitor disconnected)?
Have you checked and set your timing?
#22
I'm a terrible person
iTrader: (19)
Join Date: Apr 2009
Location: Arizona
Posts: 7,174
Total Cats: 180
Alright, my timing partner left, i'll need to finish timing it in the morning...
Unfortunately there is another issue that just came up. My clutch is dragging slightly. With the pedal out in neutral, the real wheels spin (in the air). The pedal adjustment is fully out already, to no avail. Any tips?
Unfortunately there is another issue that just came up. My clutch is dragging slightly. With the pedal out in neutral, the real wheels spin (in the air). The pedal adjustment is fully out already, to no avail. Any tips?
Engine->Clutch->Trans ... it can't spin the wheels unless it is in gear.
#23
Just something to try to check your IAT and CLT readings. With the car turned on, but not cranking or running, make sure you are getting realistic numbers for IAT (Intake Air Temp) and CLT (Coolant Temp) in Megatune (or Tunerstudio). If the car is cold, they will be close to each other and close to ambient.
Posted about this on "the other forum" and they said it was perfectly natural. i'd never had it happen before either. How odd.
Thread
Thread Starter
Forum
Replies
Last Post