Kraken G25-550 turbo questions
#1
Kraken G25-550 turbo questions
Hello everyone, I recently got my kraken turbo kit in and I had a few questions about stuff on the turbo. It's a .72ar t25 IWG turbo, so the IWG stuff is mainly what I wanted to ask some questions about.
Here's my questions:
1. What size hose should I need to fit onto the wasgate nipple?
2. Where can I buy a 90° fitting for my wastegate boost source? Im not quite sure what id look up to find it
3. How do I set IWG preload, and how should I know if it's too much or too little?
I'll provide some pictures of the turbo below
Photos:
The little hex head near the compressor is where my wastegate boost source would go, but im not sure what size thread it is, im assuming a 1/8\" NPT.
Same question about the nipple size on the wastegate, jm assuming 1/8\".
Here's my questions:
1. What size hose should I need to fit onto the wasgate nipple?
2. Where can I buy a 90° fitting for my wastegate boost source? Im not quite sure what id look up to find it
3. How do I set IWG preload, and how should I know if it's too much or too little?
I'll provide some pictures of the turbo below
Photos:
The little hex head near the compressor is where my wastegate boost source would go, but im not sure what size thread it is, im assuming a 1/8\" NPT.
Same question about the nipple size on the wastegate, jm assuming 1/8\".
Thread
Thread Starter
Forum
Replies
Last Post