Making 140whp power cap in Super Spec Cup
#1
Making 140whp power cap in Super Spec Cup
I wrote this doc for Super Spec Cup, which is the new name for the Maxxis Supermiata Cup series I built back in 2013. Some drivers have trouble making the 140whp power cap, thus the tech breakdown. I thought it might be of use to some folks here
https://supermiata.com/reaching-the-...power-cap.aspx
https://supermiata.com/reaching-the-...power-cap.aspx
__________________
#2
Great information! Thanks!
Care to elaborate on the stock throttle body mod? Encasing in high strength epoxy? JBweld or something different?
Any suggestions on a compatible TB other then the Skunk?
Do you have any pictures of the epoxy mod?
It appears as though the the throttle plate shaft has a slit machined in it and the "plate" is inserted and held into place with the screws.
That being said,I can see due to the fatigue from the twisting motion it will eventually fail.
Just looking to remove another "worry" item from the list..........if that's even possible.
Care to elaborate on the stock throttle body mod? Encasing in high strength epoxy? JBweld or something different?
Any suggestions on a compatible TB other then the Skunk?
Do you have any pictures of the epoxy mod?
It appears as though the the throttle plate shaft has a slit machined in it and the "plate" is inserted and held into place with the screws.
That being said,I can see due to the fatigue from the twisting motion it will eventually fail.
Just looking to remove another "worry" item from the list..........if that's even possible.
Thread
Thread Starter
Forum
Replies
Last Post
Good-Win Racing LLC
Good-Win-Racing - Miata Accessories
12
08-04-2011 07:47 AM