Planning a FP (F-Prepared) autocross build
#22
+1 mm valves for low end off boost torque. Doing that and some head work was epic with my new motor (same bottom end/pistons).
More boost is not the answer. More torque under the curve at all times is the best answer. More boost will just makes the car harder to launch at Pro Solos. My XP car is very difficult to launch well.
More boost is not the answer. More torque under the curve at all times is the best answer. More boost will just makes the car harder to launch at Pro Solos. My XP car is very difficult to launch well.
#23
Junior Member
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: Louisville, KY
Posts: 445
Total Cats: 15
Build is progressing....slowly, but progressing.
I ended up building my own cage. Lots of work, but saved a bunch of cash doing it myself. I've welded in some pre-built cages before. This is my first attempt from scratch.
Here's the concept drawing:
And final product:
POR15 FTW:
I ended up building my own cage. Lots of work, but saved a bunch of cash doing it myself. I've welded in some pre-built cages before. This is my first attempt from scratch.
Here's the concept drawing:
And final product:
POR15 FTW:
#24
Junior Member
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: Louisville, KY
Posts: 445
Total Cats: 15
Here's where it gets interesting....
I decided to go with Electric Power Steering. Ended up using the entire GM column and left the tilt wheel functional as well.
Column is out of a 2003 Saturn Vue. There is a guy in Portugal that sells controllers for this column on eBay. Basically a potentiometer to adjust the resistance. EPS Controller
I don't have pictures yet, but I ended up extending the rear shaft using a section of the Miata upper shaft so I could match the Miata universal spline. I was shocked to find that the GM steering wheel spline is the same as the Miata. I didn't have to mess with that side at all.
I decided to go with Electric Power Steering. Ended up using the entire GM column and left the tilt wheel functional as well.
Column is out of a 2003 Saturn Vue. There is a guy in Portugal that sells controllers for this column on eBay. Basically a potentiometer to adjust the resistance. EPS Controller
I don't have pictures yet, but I ended up extending the rear shaft using a section of the Miata upper shaft so I could match the Miata universal spline. I was shocked to find that the GM steering wheel spline is the same as the Miata. I didn't have to mess with that side at all.
Thread
Thread Starter
Forum
Replies
Last Post