megaspooge acting odd (leds)
#1
megaspooge acting odd (leds)
I fucked my firmware flash up (battery ran out) and now when I turn on my MS only the middle light comes on. What does this mean? Should I just try out the hyperterminal ****? I can't get connected to the thing anymore. I'm using a regular serial port now so my usb>serial issues aren't a problem.
MS is a Braineack one.
MS is a Braineack one.
#3
I put in the boot jumper and tried to reflash from easytherm, but I get no connectivity. I'm positive about the com port/cable/etc working fine, tested that stuff with another piece of equipment.
Hyperterminal is my only option,yes?
edit: when I don't have the boot jumper on, the middle led turns on when I turn the ignition to ON. When the boot jumper is in, I get nothing.
Hyperterminal is my only option,yes?
edit: when I don't have the boot jumper on, the middle led turns on when I turn the ignition to ON. When the boot jumper is in, I get nothing.
#5
Have you tried holding the boot jumper shorted and flashing it back to the base Megaquirt firmware, then going to whatever custom ou run?
My MS 1 chip keeps freaking out once every 60 connections or so to Megatune, and I just hit the boot jumper (I have a switch on it now) and reflash the firmware I run (MSNSE).
My MS 1 chip keeps freaking out once every 60 connections or so to Megatune, and I just hit the boot jumper (I have a switch on it now) and reflash the firmware I run (MSNSE).
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
graexodus
Miata parts for sale/trade
5
10-26-2015 01:48 PM
kronikker
Miata parts for sale/trade
17
10-06-2015 10:18 PM